This machine is microcomputer-controlled. Winding and stripping down of coils are performed simultaneously, providing a rapid work cycle. Since manual removal of coils is obviated, and operator can handle two to three of these machines and corresponding number of coil inserting machines at a time. The machines are compactly designed and permit easy maintenance. When stator specifications are changed, only the replacement of one coil former is required and this can be quickly accomplished. Besides, this machine also has following advantages :

Synchronized winding-stripping mechanism enables any number of
turns on only 15mm length of each step of the coil former to be obtained.
The transfer tool blade can be shortened.
Parallel winding is possible with no wire damage.(optional)
Concentric winding can be achieved for 3 pole, 4 pole, 6 pole
 or 8 pole. 2 pole especially can produce outstanding effect.

 
 
WIRE DIA 0.2 ~ 1.2
STATOR STACK HEIGHT 40 ~ 80mm
(R.P.M.)WINDING SPEED 3000 RPM MAX.
CONCENTRIC COILS MAX :5
EVERY STEP'S DISTANCE 15mm MAX.
NUMBER OF POLES FOR INDEX 2,4,6,8 (SINGLE OR 3PHASE)
MAX. NUMBER OF TURNS PER POLE MAX. 999
CONTROL METHOD Interface control system for servo and pneumatic
DRIVE MOTOR 6.5KW AC SERVO MOTOR
POWER 3, 220/380V, 50/60HZ
DIMENSION 160(L)*90(W)*225(H)CM
  All specifications and designs are subject to change without notice.
  Tel : 886-4-2316811
 Fax : 886-4-2318601
 Address: No.14, Lane 276, Tien-Hsiang St.
North District, Taichung, Taiwan, R.O.C.
Email : gyetay@ms15.hinet.net

Copyright 1998 GYE TAY MACHINERY WORKS
Web site designed and hosted by Taiwan Products Online